Brushless Metal Reduction Motor 500 12V High Torque (8641)
Brand new original Japanese Minebea 32mm brushless motor reduction motor, built-in drive brushless motor, support forward and reverse and pwm signal speed regulation, standard 37-type reduction box, internal all-metal gears, reduction ratio 60:1, brushless motor diameter is about 32mm, similar to the 500 motor, inside the motor housing is an outer rotor high-torque brushless motor, rare earth medium-strong magnetic rotor, the outer rotor brushless torque is very good, the measured maximum peak current is 1.5A, and the motor rated power is estimated to be around 10W.
The nominal voltage of the brushless reduction motor is 12V, and it can run at a measured voltage of 7-12V. The motor running torque is very good. According to the chip information, this model should also support 24V. The actual test shows that there is no problem running at 24V. The reliability needs to be verified, and the test is for reference only.
When wiring the brushless motor, be sure to pay attention to the positive and negative poles and do not get them wrong. Wrong wiring will instantly burn out the internal drive. The power supply must use a regulated DC power supply.
The actual measured 7-12V no-load maximum output speed of the reduction motor is as follows. The motor can also support pwm signal stepless speed regulation. The speed can be adjusted from 3 to 55 rpm at 12V voltage. The pwm signal board can be purchased separately.
Voltage 7V: no-load current 0.06A, no-load maximum speed 32 rpm.
Voltage 12V: no-load current 0.07A, no-load maximum speed 55 rpm.
The geared motor weighs about 150 grams.
Controller board dapat dilihat pada tipe (8388)
Harga per pc/ satuan