Lampu Depan Honda Fit/Lampu depan Honda Jazz Ge8 2008-2010/2008 2009 2010，Cocok untuk Penutup

Lampshade installation instructions Tools: 1 larger and deeper basin, 1 flat-blade screwdriver, 1 clean absorbent cloth, 1 pair of gloves (lint-free), 1 pair of scissors How to operate: 1. Remove the headlights from the car (this requires removing the bumper. When removing the bumper, place a cardboard box on the ground to avoid rubbing the paint on the bumper; 2. After removing the headlight, fill the basin with boiling water and press the headlight shade completely into the boiling water for 5 minutes. The glue will soften; 3. Use an absorbent cloth to quickly dry the surface of the shade and rear shell as much as possible. Apply water beads, then use a 1-shaped screwdriver to insert into the glue joint between the lampshade and the back shell (the glue is now soft), open a 10 cm long opening horizontally, and then use your hands to pull it open (to prevent the back shell from deformation); 4. Clean the glue in the glue tank of the rear shell as much as possible, put on gloves, then remove the decorative frame on the lampshade and install it on the new one. On the lampshade; 5. Use the snake glue we provide as follows: (1) Evenly spread the snake glue together with the protective paper in the glue groove of the rear shell of the headlight, and press it firmly with your hands. (2) Peel off the protective paper and use a hair dryer or hot air gun to heat the snake glue. Please do not heat the local area for a long time and ensure that the entire snake glue is heated evenly. Then close the new lampshade according to the original lamp position and compact it firmly. 6. After the installation is completed, it can be loaded into the vehicle and used.