15KV Module Generator High Voltage 15KV DC 3.7V-4.2V Arc Inverter Ignition With Coil DIY Step Up Transformer

Package Included:

- 15VKE = 1 type step-up transformer x1

- PCB Board X 1

- 120 ohm resistance X 1

- UF4007 ultra-fast recovery diode X 1

- N20 transistor X 1

- Heat sink X 1

- M3 * 6 screws X 1

- Boat switch X 1

- 3-Pin X 1

Parameter:

- 15KV transformer outside dimensions of approximately: 271621mm

- Input voltage: DC 3.7V-4.2V (limit 12v, easy to damage not recommended, this transformer is equally applicable to 12V input voltage, but requires a corresponding increase in the base of the feedback resistor to about 150 ~ 1.5K, its resistance should be large to replace a small adjustment, or burned transistor or transformer)

- Input Current: 2A

- Output voltage: approximately 15KV (please pay attention to safety when used)

- Output Current: 0.4A

- High voltage bipolar ignition distance: 0.5 cm

Installation Notes:

1). With the PCB board parts better production, in which the transformer line of thick line and thin line, this should pay attention to the other components by the board of silk symbols and parameters of welding on the line. Transformer board has done three pads, in which the middle of the pad hole is relatively large, the hole at the same time welding a thick enameled wire and a thin enameled wire, thick enameled wire and fine enameled wire do not use the same side, such as with the left Thick lines and the right side of the thin wire into or with the left side of the thin line and the right side of the thick line welding into, in short, do not use the same side of the thick lines and thin lines can be.